HDB Interior Design Singapore: TV Feature Wall Ideas

HDB interior design Singapore homeowners in new BTO flats are building feature TV walls that anchor the room, now that HDB allows open-concept kitchens. The living wall does the heavy lifting where the kitchen flows into the living space.

Pick the wall before you plan the layout

In a 4-room BTO of about 90 sqm, the TV wall is usually the one opposite the sofa. Check where the power point and the data point sit, because HDB pre-wires them. You design the feature around those points, not the other way round. Careful HDB interior design starts with the wall, not the TV model, so the build respects the points HDB already placed.

I always tell clients to stand in the kitchen and look at the wall. With an open layout, the TV wall is visible from the stove, so it has to look good from every angle. A plain panel from the kitchen side reads as unfinished.

HDB open concept kitchen and the TV wall link

New BTO kitchens are induction-ready, and HDB open concept kitchen layouts remove the wall between cooking and living. That means the TV feature wall is now the backdrop for both zones. Extend the same laminate or tile from the kitchen to the TV wall so the eye reads one continuous space.

If you cook with gas, follow SP and SCDF rules, and keep the right separation from the living area as HDB requires. The feature wall stays decorative, while the cooking zone follows its own safety limits.

HDB interior design finishes that hide the wires

The best feature walls hide every cable. Build a recessed channel behind the TV, then route power and HDMI through the carcass to a closed media drawer below. No dangling cords, no dust trap.

Use a fluted laminate or stone-look panel for texture. Quartz or solid-surface slabs work for a low ledge, while laminate keeps the cost sane for the main field. Pick one finish and repeat it so the wall feels deliberate.

Step-by-step to build a TV feature wall

1. Mark the TV centre and the viewing height. Eye level when seated is about 105 cm to 120 cm to the screen centre.
2. Decide the build type. A full carpentry wall, a half-height console with a panel above, or a recessed niche if the wall is non-structural.
3. Run the cables before the carpenter closes the back. Leave an access panel for future changes.
4. Fix the TV bracket to a stud or a reinforced panel, not bare laminate.
5. Add LED strip lighting in a top reveal for a soft glow behind the screen.
6. Finish with a low drawer for remotes and consoles, done by your HDB Licensed Renovation Contractor.

Materials and what HDB allows

HDB approves laminate carpentry and lightweight non-ceramic partitions for non-structural dividers. A full tile or stone wall needs care near structural elements. Keep the build light and fixed to approved points.

Vinyl or laminate flooring below meets HDB-approved flooring rules. If you retile, remember hacking noise is limited to weekdays 9am to 6pm, with none on Sundays and public holidays. Plan the louder days early in the HDB renovation permit window.

Your TV wall sets the mood for the whole living space, and it should not be an afterthought. Build it as part of one plan that covers the kitchen, the storage, and the bedrooms. Whole-house customization gives you one team and one look, so the feature wall feels born into the flat instead of bolted on later.