HDB Interior Design Singapore: Pasir Ris TV Feature Wall Tips
HDB interior design Singapore owners in Pasir Ris increasingly ask for a TV feature wall that hides cables and looks clean. A recent trend here is the built-in wall unit that wraps the television with storage and a recessed niche. This works well in the compact 4-room and 5-room layouts common in the estate.
Plan the feature wall around the TV size
Start by measuring the television you own or plan to buy. A 55-inch set needs a recess about 1300mm wide and 800mm tall to sit flush with the carpentry. Write the measurement down before you meet your designer. For a Pasir Ris 5-room flat near 110 sqm, the living wall is often 3 metres long, which gives room for display shelving on one side and closed cabinets on the other.
Pick the centre height. The TV centre should sit about 1050mm to 1100mm from the floor so you watch at eye level when seated. Mark this on the wall with painter tape. Your HDB Licensed Renovation Contractor will use this mark to set the frame.
Choose HDB-approved materials and finishes
HDB allows laminate carpentry, quartz or solid-surface countertops, and lightweight non-ceramic partitions for non-structural dividers. For a TV wall, most owners use laminate panels because they are light and meet rules. Avoid heavy stone cladding on a non-load-bearing divider, since the wall may not take the weight.
- Laminate with a wood grain for a warm look that suits Pasir Ris coastal homes.
- Fluted panels to add vertical lines without extra cost.
- Matte finishes to cut glare from the screen.
- A quartz ledge below the TV for the set-top box and remote.
Keep the colour calm. A light oak or warm grey reads well on camera and in the room. You can add one storage niche in a deeper tone for contrast.
Hide cables with a proper route
Cable mess is the main reason a feature wall looks cheap. Ask your contractor to cut a trunking channel behind the TV and run the wires to a low cabinet. The HDB renovation permit covers this kind of carpentry work, and processing takes about 2 weeks, so plan early. Put a brush plate at the back of the niche so cables pass cleanly.
- Decide where the console and media player sit.
- Drill a channel from the TV height down to the console level.
- Fit a power point inside the cabinet, not behind the screen.
- Bundle the HDMI and power cords with velcro ties.
- Close the panel and check that nothing pulls when you swivel the set.
Use light to set the mood
Add an LED strip behind the recess for a soft glow. Use a warm 2700K to 3000K strip on a dimmer. This makes the wall feel deeper and keeps the screen readable at night. For a Pasir Ris home, a dimmable strip also helps during movie nights with the family.
Consider a picture light above the display shelf if you show books or art. Keep the wattage low so it does not wash out the TV.
Add storage that earns its place
HDB flat space saving matters in Pasir Ris, where many families keep sports gear and school bags in the living area. Build closed cabinets at the ends of the feature wall to hide clutter. A single open shelf across the top holds a few items, not a crowded row.
A pull-out troupe for the set-top box, or a small drawer for remotes, keeps the ledge clear. The result is a wall that stores as much as it shows.
When you work with a whole-house customization team on your Pasir Ris flat, the TV feature wall becomes part of one plan rather than a last-minute add-on. You get a wall that fits the room size, hides the cables, and leaves space for the things you use every day. That is the practical way to make HDB interior design work for a busy household.
